Pengaruh Waktu Milling Terhadap Mikrostruktur dan Sifat Magnetik Komposit NiFe2O4-NdFeO3 [Influence Of Milling Time on Microstructure and Magnetic Properties of NiFe2O4-NdFeO3 Composite]

Ade Mulyawan, Yunasfi Yunasfi, Wisnu Ari Adi


The development of electromagnetic wave and microwave absorbing materials was important to overcome the electromagnetic wave interference in communication technology and in the development of radar materials for military purposes. In this study the composite which contained two different phases of NiFe2O4-NdFeOhas successfully synthesized using Fe2O3, NiO, and Nd2Oas starting materials through solid state reaction method. The composites were made by varying milling times from 10, 15, 20, and 25 hours then followed by sintering process at 1200 °C for 3 hoursPhase identification was performed using XRD (x-ray diffractometer) which revealed only NiFe2O4 and NdFeOphases. The crystallite size of the NiFe2Ophase is in the range of 59-68 nm, and NdFeO3in the range of 62-65 nm. The agglomeration of particles was observed by using SEM (scanning electron microscope). Referring to the characterization result of the magnetic properties by using VSM (vibrating sample magnetometer), it is known that the parameters of the magnetic properties such as magnetization saturation (Ms), magnetization remanence (Mr), and coercivity (Hc) are highly dependent on the mass fraction, crystallite size,and the homogenity of the phase composition.


Pengembangan bahan penyerap gelombang elektromagnetik dan gelombang mikro sangat penting dilakukan untuk mengatasi masalah interferensi gelombang elektromagnetik pada teknologi komunikasi serta pada material radar untuk tujuan militer. Pada penelitian ini berhasil dilakukan pembuatan material penyerap gelombang elektromagnetik komposit fasa NiFe2O4-NdFeO3 dengan menggunakan Fe2O3, NiO, dan Nd2O3 melalui reaksi padatan. Sampel komposit dimilling dengan variasi waktu 10, 15, 20, dan 25 jam dan selanjutnya disinter pada suhu 1200 oC selama 3 jam. Identifikasi fasa dilakukan dengan X-ray Diffractometer (XRD) menunjukan bahwa komposit hanya terdiri dari fasa NiFe2O4 dan NdFeO3. Ukuran kristalit fasa NiFe2O4 berada pada kisaran 59-68 nm, sedangkan fasa NdFeO3 pada kisaran 62-65 nm. Pengamatan morfologi permukaan dilakukan menggunakan Scanning Electron Microscope (SEM). Berdasarkan nilai parameter sifat magnetik yang dihasilkan menggunakan Vibrating Sample Magnetometer (VSM) seperti magnetisasi saturasi(Ms), magnetisasi remanen (Mr), dan koesivitas (Hc) sangat bergantung pada fraksi massa, ukuran kristalit, dan homogenitas fasa yang terbentuk.


Penyerap gelombang elektromagnetik; komposit NiFe2O4-NdFeO3; waktu milling; sifat magnet; Electromagnetic wave absorbing; NiFe2O4-NdFeO3 composite; milling time; magnetic properties


S. Hazra, M. K. Fatra, dan B. K. Ghosh, “A novel „one-pot‟ synthetic method for preparation of (Ni0.65Zn0.35Fe2O4)x(BaFe12O19)1 nanocomposites and study of their microwave absorption and magnetic properties,” Powder Technology, vol. 279, pp.1017, 2015.DOI: 10.1016/j.powtec.2015.03.04

W. Zhu, L. Wang, R. Zhao, J. Ren, G. Lu, dan Y. Wang, “Electromagnetic and microwave-absorbing properties of magnetic nickel ferrite nanocrystals,” Nanoscale, vol. 3, pp. 2862-64, 2011. DOI: 10.1039/c1nr10274e

Nejati, Kamellia, dan R. Zabihi, “Preparation and magnetic properties of nano size nickel ferrite particles using hydrothermal method,” Chemistry Central Journal, vol. 6, pp. 1-6, 2012. DOI: 10.1186/1752-153X-6-23.

G. Song, B. Kang, J. Jiang, dan S. Cao, “Spin reorientation transition process in single crystal NdFeO3,” Solid State Communications, vol. 211, pp. 47-51, 2016.DOI : 10.1016/j.ssc.2015.03.013

S. J. Yuan, W. Ren, F. Hong, Y. B. Wang, J. C. Zhang, L. Bellaiche, S. X. Cao, dan G. Cao, “Spin switching and magnetization reversal in single-crystal NdFeO3,” Physical Review B - Condensed Matter and Materials Physics, vol. 87, pp.1-6, 2013.  DOI: 10.1103/PhysRevB.87.184405

Manaf, dan W. A. Adi, “Analisis struktur single phase sistem Ba1- xLaxMnO3 (0

R. Mukherjee, G. Lawes, dan B. Nadgorny, “Enhancement of dielectric constant in LaFeO3-NiFe2O4 composites,” Proceedings of the 14th Asian Conference on Solid State Ionics, 2014, pp.187-196. DOI : 10.3850/978-981-09-1137-9_044

B. Bajac, J. Vukmirović, I. Tokić, S. Ognjanović, dan V. V. Srdić, “Synthesis and characterization of multilayered BaTiO3/NiFe2O4 thin films,” Processing and Application of Ceramics, vol. 7, pp. 15–20, 2013. DOI : 10.2298/PAC1301015B

H. Kavas, N. Kasapoğlu, A. Baykal, dan Y. Köseoğlu, “Characterization of NiFe2O4 nanoparticles synthesized by various methods,” Chemical Papers, vol. 63, pp. 450-55, 2009. DOI : 10.2478/s11696-009-0034-6

Yunasfi, W. A. Adi, Mashadi, dan P. A. Rahmy, “Magnetic and microwave absorption properties of nickel ferrite (NixFe3-xO4) by HEM technique,” Malaysian Journal of Fundamental and Applied Sciences, vol. 13, no. 3, pp. 203- 206, 2017. DOI : 10.11113/mjfas.v13n3.553)

Mashadi, Yunasfi, dan W. A. Adi, “Analisis struktur kristal dan gugus fungsi NiFe2O4 hasil sintesis dengan metoda sol gel,” Indonesian Journal of Material Science, vol. 17, no. 3, pp.131- 135, 2016.

N. Chen dan M. Gu, “Microstructure and microwave absorption properties of Ysubstituted Ni-Zn Ferrite,” Open Journal of Metal, vol. 2, pp. 37-41, 2012. DOI:10.4236/ojmetal.2012.22006)

M. Kurian, S. Thankachan, D. S. Nair, E. K. Aswathy, A. Babu, A. Thomas, dan K. T. B. Krishna, “Structural, magnetic, and acidic properties of cobalt ferrite nanoparticles synthesised by wet chemical methods,” Journal of Advanced Ceramics, vol. 4, pp.199-205, 2015. DOI : 0.1007/s40145-015-0149-x

G. Nabiyouni, M. J. Fesharaki, M. Mozafari dan J. Amighian, “Characterization and magnetic properties of nickel ferrite nanoparticles prepared by ball milling technique,” Chin. Phys. Lett., vol. 27, no. 12, pp. 126401(1-4), 2010. DOI: 10.1088/0256-307X/27/12/126401

P. V. Serna, C. G. Campos, F. S. De Jesús, A. M. B. Miró, J. A. J. Lorán, dan J. Longwell, “Mechanosynthesis, crystal structure and magnetic characterization of neodymium orthoferrite,” Materials Research, vol. 19, pp. 389-393, 2016. DOI: 10.1590/1980-5373-MR-2015-0214

M. G. Naseri, E. B. Saion, dan A. H. Shaari, “Role of PVP on the phase composition and morphology of manganese ferrite nanoparticles prepared by thermal treatment method,” International Nano Letters, vol. 48, pp. 169-73, 2012. DOI: 10.7763/IPCBEE. 2012. V48. 32

W. A. Adi, “Mekanisme pembentukan fasa Mg2Ni dengan metode mechanical alloying,” Indonesian Journal of Material Science, vol. 1, pp. 60-65, 2008.

S. Thankachan, M. Kurian, D. S. Nair, S. Xavier, dan E. M. Mohammed,“Effect of rare earth doping on structural, magnetic, electrical properties of magnesium ferrite and its catalytic activity,” International Journal of Engineering Science and Innovative Technology (IJESIT), vol. 3, no. 4, pp. 529-537, 2014.

P. R. Babu dan R. Babu, “Starch assisted sol gel synthesises and characterization of NdFeO3.” International Journal of ChemTech Research, vol. 9, no. 4, pp. 364-373, 2016.

B. Issa, I. M. Obaidat, B. A. Albiss, dan Y. Haik, “Magnetic nanoparticles: Surface effects and properties related to biomedicine applications,” International Journal of Molecular Sciences, vol. 14, no. 11, pp. 21266–305, 2013. DOI: 10.3390/ijms141121266 •

Copyright (c) 2018 Metalurgi
Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.


  • There are currently no refbacks.